COLOS CONTROL PRO 5.0 SLOW CONNECTION HOW TO
COLOS CONTROL PRO 5.0 SLOW CONNECTION SOFTWARE

Starting from GRBL v1.1 there is a new feature of GRBL called вЂњLaser ModeвЂќ. If your Laser does not support power modulation via ttl-pwm with S code, but only ON-OFF operation by M3-M5, please uncheck this flag.ДЄll LaserGRBL feature that require power modulation will be hidden, and laser control will be done only via M3-M5 instead of S command. Other firmwareД®ngraver based on Ruida, Mach3, Benbox etc are not supported by LaserGRBL. (tested with USB cable only, no WiFi support). LaserGRBL implement a sort of emulation of this protocol but their protocol is buggy and undocumented, so expect issue. This engraver uses a non-grbl compatible protocol and only work with their VigoWork software. In mid-2020 Vigotec has released a new model L7X with WiFi connection. It is assumed that LaserGRBL is able to communicate with Marlin, but the gcode generated by LaserGRBL could be not 100% compatible. Marlin firmware support is in a very early stage.

For more information about usage with smoothie please see this page. LaserGRBL also have an experimental support for Smoothieboard with smoothie firmware. This includes a lot of commercial and DIY laser engraver/cutter and CNC. LaserGRBL is designed to talk with control board based on Arduino Uno/Nano and GRBL firmware. However is still useful to properly set up some information that LaserGRBL can not know about your hardware. Given its simplicity, LaserGRBL avoids as much as possible confusing you with so many configurations. Italian version: Configurazione Grbl ITA LaserGRBL configuration Here is a guide for GRBL configuration: Grbl Configuration ENG

COLOS CONTROL PRO 5.0 SLOW CONNECTION SOFTWARE

This software is called GRBL, and needs to be configured through special commands or through a convenient configuration window available on LaserGRBL.

The heart of a laser marker is hidden in its control board, on which there is a small chip on which runs a software capable of transforming the commands it receives from LaserGRBL (which in jargon are called g-code commands) into the right impulses to move the motors and to control the laser.

COLOS CONTROL PRO 5.0 SLOW CONNECTION HOW TO

Before you get started, there are a few things you should know about your engraver and how to set it up to get the most out of your jobs.

Colos control pro 5.0 slow connection